EASY WAYS TO REPLACE 3 TONNE CLUTCH LINING TOYOTA FORKLIFT

This time we discuss the replacement of the 3 tonne forklift manual clutch lining, for those who already understand and are used to doing this work it may not be so difficult but for beginners or those who have never done it, they will definitely ask how to remove the clutch lining starting from where. Because if you look at a glance between the transmission and the engine so tightly while the clutch lining is right in the middle.

 

  • Here are the steps to remove the clutch lining:
  • First open the transmission cover that is above the clutch lining
  • Then to make it easier just remove the release cilinder or the lower clutch master to make it more free
  • Then look for the locking wire located on the clutch axle in front of the bearing, namely there is a slight hole gap just turn the clutch axle later the locking wire will be seen and pull it out using pliers
  • After the locking wire is unplugged then pry or push back the clutch axle using a screwdriver
  • Next, press the clucth cover or screw using a bolt, how to find the bolt holes around the screw, usually there are four
  • Then remove the circumferential screw bolt attached to the flywhell or flywheel
  • Then lift the clutch lining or can be together with the coupler

Easy right… so there is no need to lower the engine to replace the clutch lining after removing all the damaged parts, then we replace the new clutch lining.

  • How to install a 3 tonne toyota clutch lining:

After we discuss how to remove it, we discuss how to install it, what needs to be noted is that the spare parts that are removed last are installed first, namely or the opposite of how to remove it.

  • Install the new clutch lining first, or you can also use the decoupler as well.
  • Then pry back the clutch axle and make sure it enters the gear groove until the end of the axle is stuck to the flywheel.
  • Then reinstall the axle lock wire
  • If it’s finished, continue installing the screwdriver bolt to the flywheel
  • Continue to install the release cylinder
  • and finally open the press screw bolt

Check the possibility that something is not right if it feels a little difficult to shift gears or reduced power can be adjusted in the clutch stud section.

 

Source : https://serviceforkliftlky.blogspot.com/2015/01/cara-mudah-mengganti-kanvas-kopling.html

Tinggalkan Komentar

Alamat email Anda tidak akan dipublikasikan. Ruas yang wajib ditandai *

Keranjang Belanja